BME280 Environmental Sensor
Sensor enable real-time monitoring of temperature, humidity and barometric pressure
This product is a high-precision environmental sensor equipped with a BME280 sensor. It allows for monitoring of temperature, humidity, and barometric pressure. The chip can sense temperatures ranging from -40 to +85°C, humidity from 0 to 100%, and barometric pressure from 300 to 1100hPa. The module can be connected to a development board for environmental detection using a PH2.0 6PIN wire. Demo codes are available for Arduino, Raspberry Pi (in both C and Python), and STM32 versions. These demo codes enable real-time monitoring of temperature, humidity, and barometric pressure.
Product Features
※ I2C (default) and SPI interfaces can be easy to convert- ※ Onboard RT9193-33 LDO Regulator, Ultra-Low-Power, Quick Start-Up
- ※ Open source demo codes available for Raspberry Pi, Arduino and STM32 development boards
Specifications
| Dimensions | 30mm(length) x 18mm(Width) |
| sensor chip | BME280 |
| Signal interface | I2C/SPI |
| Supply voltage | 3.3V/5V |
| Temperature sensing | -40~85°C(resolution 0.01°C, accuracy±1°C) |
| Humidity sensing | 0~100%RH (resolution 0.008%RH, accuracy ±3%RH) |
| Barometric Pressure sensing | 300~1100hPa (resolution 0.18Pa, accuracy ±1hPa) |
Integrated BME280 Sensor: Provides measurements for temperature, humidity, and atmospheric pressure
Open source demo codes available for Raspberry Pi, Arduino and STM32 development boards
Flexible Interface Options: Supports both I2C and SPI communication interfaces, with I2C set as the default
Onboard RT9193-33 LDO Regulator
Interface Definition
| PIN | I2C | SPI |
|---|---|---|
| VCC | Power supply positive(3.3V/5V) | Power supply positive(3.3V/5V) |
| GND | Power supply grond | Power supply ground |
| SCK | clock line | clock input |
| MOSI | data line | data input |
| MISO/ADDR | NC | data output |
| CS | NC | SPI chip selection pin(active at low level) |
Resource overview
- ① PH2.0 6PIN Module wire
- ② RT9193-33 LDO Regulato
- ③ BME280 Precision Sensor
- ④ DIP switch is used to select the I2C address
- Dimensions
WIKI
Package Contents
- BME280 Environmental Sensor x1
- PH2.0 6PIN connecting cable x1
